HR532/HR1064 High-Power Reflective Window

High-power reflective window that reflects over 99% at both 532 nm and 1,064 nm, letting only 0.01% through at those lines.

Need a different size or spec? We make custom versions.

BANDOPTIC spectrum engine

Interactive Spectrum

Plot and compare optical filter spectra. Catalog curves digitized from the supplied PDFs are approximate references; request measured data for specifications.

Choose a filter from the catalog or upload a numerical CSV.

Request measured data

Catalog curves are approximate digital tracings of PDF graph images, not instrument CSV or guaranteed production-lot results. Some curves show only the plotted peak or cut-on edge; open the source graph for its full context. For approximate traces, OD values at or below 2% transmission are hidden because raster plots cannot verify blocking performance. Uploaded CSV files stay in your browser. Andover numerical curves will be added only when source data is available.

Technical Specifications

SpecificationValue
ReflectionR > 99% at 532 nm and 1,064 nm
Transmission in reflect bands0.01%
Laser damage threshold> 10 J/cm² at 1,064 nm, 10 ns pulses
Angle of incidence0°
Cone half-angle3.5°
SubstrateFused silica (JGS1)
Thickness1.0 ± 0.1 mm
Dimensional tolerance+0 / −0.1 mm
Surface quality60-40 scratch-dig
Clear aperture≥ 90% of diameter

Sizes

Need custom requirements? We cut to your drawing.

SizeThicknessMount
Ø12.5 mm1.0 mmUnmounted
Ø25 mm1.0 mmUnmounted or ringed
12.5 × 12.5 mm1.0 mmUnmounted

Other sizes and shapes are cut to order.

Choosing This Filter

This reflective window reflects more than 99% at both 532 nm and 1,064 nm and lets only 0.01% through at those lines. A frequency-doubled Nd:YAG laser emits at both wavelengths, so a single window can keep both out of a viewing port, a camera or an operator’s line of sight while visible light outside the two bands still passes. The exact reflect-band edges are being confirmed; our curve shows blocking around 510 to 560 nm and 960 to 1,100 nm. Tell us your laser power and pulse length. For a window that passes 1,064 nm instead, see the 1,064 nm protective window.

Customization Options

Need a different wavelength, width or blocking? We design it to order.

We can move the center wavelength anywhere from 200 to 2,500 nm, change the width, block deeper, up to OD6, or further into the infrared, and cut the filter to your size and thickness.

Tell us your light source, your detector and the numbers you need. We will reply with a recommended design and a quote, from a single prototype to production volumes.

See what we can make on our custom filters page. Learn more

FAQs

Can I tilt this filter?

A small tilt, up to about 2°, stays within spec. At larger angles the coating behaves differently, so if your design puts this part at an angle, tell us the angle and we will design for it.

How should I clean and store it?

Hold the filter by its edges. Blow off dust first, then wipe gently with lens tissue and reagent-grade isopropyl alcohol if needed. Store it dry, in its case, away from direct sunlight.

Can I get the measured curve with my order?

Yes. Ask for it when you order, and we include the measured transmission of your batch, as a chart and as a data file.

Don’t see the filter you need? Tell us about your system and we will suggest one or design it. Learn more