IPL Filters

Reflective cut-off filters at 640 nm, 900 nm and dual-band

IPL Filters and Handpiece

Reflective Cut-Off Filters for Intense Pulsed Light Devices

An IPL lamp emits a broad spectrum. The cut-off filter in the handpiece decides which part of it reaches the skin.

We make three IPL filters: 640 nm and 900 nm longpass filters, and a dual-band filter passing 500–650 and 900–1,800 nm.

Each transmits over 92% in its pass band and reflects over 98% of the light it blocks, from 200 nm up.

All three are designed for 0 ± 2° incidence with a 3° cone half-angle.

Our hard dielectric coatings operate up to +200 °C, which suits the heat inside an IPL handpiece.

Rectangular IPL optical cut off filter plates

Need another cut-off or size? Specify a custom IPL filter

What an IPL Filter Does

A xenon flash lamp emits from the ultraviolet to the infrared. The filter removes the short wavelengths below its cut-on and passes the band the device is designed to deliver.

Our IPL filters block by reflection, not absorption. Rejected light is sent back toward the lamp instead of heating the filter.

The cut-on wavelength is set by the device maker. We build to the band you specify.

Xenon 640nm GuideD01 · IMAGE PENDINGXenon lamp spectrum and the band passed after a 640 nm cut-off
Figure: Xenon lamp spectrum and the band passed after a 640 nm cut-off.

The xenon lamp spectrum is compared with a 640 nm cut-off to show which wavelengths pass through the IPL filter.

Our Three IPL Filters

IPL640nm. A longpass filter that reflects 200 to 630 nm and transmits 650 to 1,100 nm. ipl640nm

IPL900nm. A longpass filter that reflects 200 to 880 nm and transmits 910 to 1,800 nm, for devices that deliver only near-infrared light. ipl900nm

IPL Dual-Band. Two pass bands, 500 to 650 nm and 900 to 1,800 nm, with reflection from 200 to 480 nm and from 700 to 870 nm. It removes the ultraviolet and the deep red to near-infrared gap in one filter. ipl dual band 500 650 900 1800

IPL Filters Compared

Model Transmits (Tabs > 92%) Reflects (Rabs > 98%) AOI Cone half-angle
IPL640nm 650–1,100 nm 200–630 nm 0 ± 2° 3.0°
IPL Dual-Band 500–650 and 900–1,800 nm 200–480 and 700–870 nm 0 ± 2° 3.0°
IPL900nm 910–1,800 nm 200–880 nm 0 ± 2° 3.0°

Sizes are cut to your handpiece or light guide.

Angle and heat. Light from an IPL lamp reaches the filter over a wide range of angles, and the edge of an interference filter moves to shorter wavelengths as the angle grows. Our IPL filters are specified at 0 ± 2° with a 3° cone, so tell us how light reaches the filter in your handpiece; we can shift the design to keep the cut-on where you need it. Also tell us your pulse energy and repetition rate.

What to Send Us

  • Cut-on or pass bands you need
  • Filter size and thickness
  • How light reaches the filter
  • Pulse energy and repetition rate
  • Annual volume

Building or servicing IPL handpieces? Send us the band, size and lamp details, and we will match one of our filters or design a new cut-off, and send a quote. Contact us