ND 50%@300-1800
Broadband neutral density filter with 50% average transmission, about OD 0.3, from 300 to 1,800 nm.
Need a different size or spec? We make custom versions.
BANDOPTIC spectrum engine
Interactive Spectrum
Plot and compare optical filter spectra. Catalog curves digitized from the supplied PDFs are approximate references; request measured data for specifications.
Catalog curves are approximate digital tracings of PDF graph images, not instrument CSV or guaranteed production-lot results. Some curves show only the plotted peak or cut-on edge; open the source graph for its full context. For approximate traces, OD values at or below 2% transmission are hidden because raster plots cannot verify blocking performance. Uploaded CSV files stay in your browser. Andover numerical curves will be added only when source data is available.
Technical Specifications
| Specification | Value |
|---|---|
| Transmission | 50% (average), 300–1,800 nm |
| Optical density | OD 0.3 |
| Tolerance | ± 5 percentage points |
| Type | Broadband attenuator |
| Angle of incidence | 0 ± 2° |
| Cone half-angle | 3.5° |
| Substrate | Fused silica (JGS1) |
| Thickness | 1.0 ± 0.1 mm |
| Dimensional tolerance | +0 / −0.1 mm |
| Surface quality | 60-40 scratch-dig |
| Clear aperture | ≥ 90% of diameter |
Sizes
Need custom requirements? We cut to your drawing.
| Size | Thickness | Mount |
|---|---|---|
| Ø12.5 mm | 1.0 mm | Unmounted |
| Ø25 mm | 1.0 mm | Unmounted or ringed |
| 12.5 × 12.5 mm | 1.0 mm | Unmounted |
Other sizes and shapes are cut to order.
Choosing This Filter
This broadband neutral density filter transmits 50% on average, about OD 0.3, from 300 to 1,800 nm. Its range runs from the UV through the visible into the short-wave infrared, so a single filter halves the light seen by silicon and InGaAs detectors alike. Use it to balance two channels, reduce a signal by a known factor across a wide spectrum, or check detector linearity with UV, visible and SWIR sources. For deeper attenuation over 350 to 1,100 nm, see ND 10%; for OD3 in the visible, the reflective ND filter in the cards below.
Customization Options
Need a different wavelength, width or blocking? We design it to order.
We can move the center wavelength anywhere from 200 to 2,500 nm, change the width, block deeper, up to OD6, or further into the infrared, and cut the filter to your size and thickness.
Tell us your light source, your detector and the numbers you need. We will reply with a recommended design and a quote, from a single prototype to production volumes.
See what we can make on our custom filters page. Learn more
Related Filters
FAQs
Can I tilt this filter?
A small tilt, up to about 2°, stays within spec. At larger angles the coating behaves differently, so if your design puts this part at an angle, tell us the angle and we will design for it.
How should I clean and store it?
Hold the filter by its edges. Blow off dust first, then wipe gently with lens tissue and reagent-grade isopropyl alcohol if needed. Store it dry, in its case, away from direct sunlight.
Can I get the measured curve with my order?
Yes. Ask for it when you order, and we include the measured transmission of your batch, as a chart and as a data file.
Don’t see the filter you need? Tell us about your system and we will suggest one or design it. Learn more