BPF2100-50

2,100 nm infrared bandpass filter, 50 nm wide, with OD6 blocking from 400 to 2,062 nm and from 2,145 to 3,000 nm.

Need a different size or spec? We make custom versions.

BANDOPTIC spectrum engine

Interactive Spectrum

Plot and compare optical filter spectra. Catalog curves digitized from the supplied PDFs are approximate references; request measured data for specifications.

Choose a filter from the catalog or upload a numerical CSV.

Request measured data

Catalog curves are approximate digital tracings of PDF graph images, not instrument CSV or guaranteed production-lot results. Some curves show only the plotted peak or cut-on edge; open the source graph for its full context. For approximate traces, OD values at or below 2% transmission are hidden because raster plots cannot verify blocking performance. Uploaded CSV files stay in your browser. Andover numerical curves will be added only when source data is available.

Technical Specifications

SpecificationValue
Center wavelength (CWL)2,100 ± 2 nm
Bandwidth (FWHM)50 ± 2 nm
Transmission> 92% at 2,100 nm
Blocking, short sideOD > 6 (average), 400–2,062 nm
Blocking, long sideOD > 6 (average), 2,145–3,000 nm
Angle of incidence0 ± 2°
Cone half-angle3.5°
SubstrateOptical glass (K9 / B270)
Thickness1.0 ± 0.1 mm
Dimensional tolerance+0 / −0.1 mm
Surface quality60-40 scratch-dig
Clear aperture≥ 90% of diameter

Sizes

Need custom requirements? We cut to your drawing.

SizeThicknessMount
Ø12.5 mm1.0 mmUnmounted
Ø25 mm1.0 mmUnmounted or ringed
12.5 × 12.5 mm1.0 mmUnmounted

Other sizes and shapes are cut to order.

Choosing This Filter

BPF2100-50 passes a 50 nm band at 2,100 nm with more than 92% transmission and blocks to OD6 from 400 to 2,062 nm and from 2,145 to 3,000 nm. 2.1 µm is the wavelength of holmium lasers and a window used in SWIR gas and moisture sensing beyond the water band at 1.94 µm. The deep blocking on both sides makes it suitable for receivers that must ignore strong shorter-wavelength sources. For 1,940 nm, see BPF1940-50; for the mid-infrared, BPF3950-100.

Customization Options

Need a different wavelength, width or blocking? We design it to order.

We can move the center wavelength anywhere from 200 to 2,500 nm, change the width, block deeper, up to OD6, or further into the infrared, and cut the filter to your size and thickness.

Tell us your light source, your detector and the numbers you need. We will reply with a recommended design and a quote, from a single prototype to production volumes.

See what we can make on our custom filters page. Learn more

FAQs

Can I tilt this filter?

A small tilt, up to about 2°, stays within spec. Beyond that, the passband moves to shorter wavelengths, and the further you tilt, the further it moves. If your design needs a tilt, tell us the angle and we will design for it.

How should I clean and store it?

Hold the filter by its edges. Blow off dust first, then wipe gently with lens tissue and reagent-grade isopropyl alcohol if needed. Store it dry, in its case, away from direct sunlight.

Can I get the measured curve with my order?

Yes. Ask for it when you order, and we include the measured transmission of your batch, as a chart and as a data file.

Don’t see the filter you need? Tell us about your system and we will suggest one or design it. Learn more